Original LXSeries Forum

Quand je produis un report les locations des projecteurs indiquent le positionnement, mais pas avec le - ou + impossible de savoir si c'est a jardin ou cour du centre.
Sur le plan cela indique bien le X et Y en positif ou négatif du point 0.

LXBeams and LXFree us a cartesian coordinate system with the x and y axis as usual. Positive Y is towards the top of the screen and would normally be upstage in a drawing. Negative Y is towards the bottom of the screen (downstage). Positive X is to the right of the screen. With upstage at the top, this is stage left or coté cour. Negative X is to the left of the drawing. This is stage right or coté jardin.

            +Y (US)

-X (SR)    *         +X (SL)

             -Y (DS)

The origin point (*) is set in the Inspector's Document tab. At the top are choices between setup and coordinates. Under coordinates, there are several ways to set the origin (0,0). Probably the most useful is the popup menu. There is a command called "Next Click Sets Origin". After selecting this menu item, the next click on the drawing will establish (0, 0).

Note: Perhaps this is not the question asked or someone can answer better in French.

La publication d'origine demande que la colonne de localisation dans les rapports inclue une annotation indiquant la direction de la distance lorsque les mises en page sont positionnées au centre.

Vous pouvez le faire avec la dernière version de LXBeams, 5.1.1. Sur la page des téléchargements, sous "Autres téléchargements", vous trouverez le lien vers cette version.

The original post is asking that the location column in reports include an annotation indicating the direction of the distance when positions have their layout set to center.

You can do this with the latest build of LXBeams, 5.1.1. On the downloads page, under "Other Downloads" you will find the link to this version.